Process of Making Homemade Solar Cells

People of present days should be really thankful with the proven fact that the technology that revolves around homemade solar cells has become more effective and reasonable. Truth is, most of the people can agree that making one is a piece of cake, that everyone appears to turn the activity of making solar cells into a family project that they can do during weekends while sharing flavorsome Bbq's with all the family.
Solar cells, which is known to be a photovoltaic cells is largely a part which is used in the conversion of the energy gathered from the sun into electric energy by way of photovoltaic effect. Solar power is the energy gathered from the sun thru the least costly demeanour of gathering electricity. Now in case you want to form your own homemade solar cells, you can simply follow the strategy given below :
The materials that you will need to complete this project are copper flashing, electric wire, sodium bicarbonate or you can use table salt, electric stove, transparent compact disk case, hot glue solder and sheet metal shears which will be used in cutting copper sheets.
Initiate the process by cutting the metal sheet dependent on the scale of the burner of the oven. It's very important that you wash the copper sheet totally employing a cleaner or soap. When you're done washing, make sure that there is no oil or grease stains, then clean it with wire brush to lose sulphide.
This is the time to put the sheet into the burner then start the burner. Permit the sheet to stay on the burner for about half an hour. When the metal starts to turn hot while the burner becomes red, a coating of cupric oxide will occur on the metal. It is very important for the coat to be thick enough so it might be flaked simply.Now you can chill the hot copper slowly.Due to this, it's the time to switch off the burner while permitting the sheet to remain on the same position for it to cool down slowly. In case you allow it to chill instantly then it'd stick on the metal.
Permit the copper to be cool at a comfortable temperature. Cut another sheet of metal then you must solder a wire into every one of the copper plates then you can insulate the soldering thru the use of glue.
Seal the plates then you can fill it up with baking soda and water.Also, it is permitted to use cooking salt.
When you're prepared, test the cell when there's a robust daylight.